Part #1031734 RevA
WITH LEVERS OPEN, slide towers onto bases.
Tighten tower screws
after crossbars are
centered.
If crossbar will not slide in,
loosen tower screw.
If lever WILL NOT CLOSE COMPLETELY—
make sure the base is aligned to the tower.
TEST INSTALLATION
by pulling on each
tower and each bar.
Some play between
tower and base is
normal.
Install end
caps on
crossbars.
NOTE: Closing the
levers secures
towers to bases.
CLOSE levers on all towers.
Slide towers
onto crossbars.
Install SKS
®
Locks
(purchased separately)
using lock instructions.
Rotate the small hole inside the
lock housing so that the point on
the core will align properly.
DO NOT EXCEED
WEIGHT LIMIT OF 150 LBS.
SECURE LONG LOADS at the
front and rear.
