background image

1033309E-3/24

SECURE THE FRAME POSITION.

t5VSOBOEQVTIUIFSFEUSJHHFST

until they are seated in the hub.

t.PWFUIFGSBNFTBQBSUWFSZ

slightly until the red triggers 
snap. 

t*GUIFGSBNFGFFMTMPPTFQVMMPVU

the red triggers and try again.

Do not allow the frames 

to move out of position. 

Check your measurement 

again if necessary.

Lower support frame location is 
extremely important to the load!

Read and follow the notes 
for your vehicle. 

LOWER FRAME.

Clean the contact points 

on the vehicle, and keep 

the pads free of debris.

CAUTIONS:

t%POPUQMBDFUIFMPXFSGSBNFPOHMBTT

plastic, or thin metal.

t4PNF467TWBOTBOEXBHPOTIBWFBMBSHF

section of poorly supported metal that will 
dent under weight.

UNLISTED VEHICLES: 

t"DPNNPOMPDBUJPOJTBXFMM

supported license plate depression, 

KVTUBCPWFPSCFMPXUIFOVNCFST

t1SFTTUIFBSFBmSNMZXJUIZPVS

hand. If deformation occurs, choose 
another location.

CARRIER IS 
READY TO PLACE 
ON CAR.

POSITION UPPER HOOKS.

Place where directed 
by the Fit Sheet Notes.

WARNING: DO NOT ATTACH THE UPPER HOOKS TO GLASS OR PLASTIC!  IN ADDITION, 

THE USE OF GLASS HATCH HOOKS WILL LIMIT THE LOAD TO 2 BIKES ONLY.

(If upper hooks must attach to glass or plastic, follow Glass Hatch Hooks installation on next page.)

UNLISTED VEHICLES: 

UPPER HOOKS

t*OTFSUUIFVQQFSIPPLT

into the leading edge of 
the hatch or trunk.

Refer to notes for your 
vehicle to see if you 
should use the Glass 
Hatch Hooks in place 
of the top or bottom 
hooks.

NO GLASS OR PLASTIC? You won’t need the Glass Hatch Hooks, continue to step 13.

CAUTIONS:

t*GIPPLTEPOPUmUJOUPUIFMFBEJOH

edge of the hatch or trunk, you can 
install the Glass Hatch Hooks.

t*GUIFMFBEJOHFEHFPGUIFIBUDIPS

trunk has trim, you must use the 
Glass Hatch Hooks.

t3FNPWFIPPLTCFGPSFPQFOJOHUIF

hatch or trunk. Opening the hatch 
or trunk with hooks installed could 
cause damage to the vehicle.

Summary of Contents for LittleJoe









Reviews: