Instruction #1036039A - page 2 of 10
ASSEMBLY AND INSTALLATION
INSERT THE EXO TOPSHELF™ MAST.
EXTEND THE DRIVER-SIDE ARM.
REMOVE THE END CAP.
Extend the driver-side arm of the EXO
SwingBase™ by pulling the pin and swinging
it outward until the arm locks into place.
Push in the tab and remove the end cap.
Store the end cap in a safe place.
CAUTION:
Keep your
fingers away
from ALL
moving parts!
A. Insert the mast into the EXO SwingBase™ as shown.
B. Use the provided 6 mm wrench to install 2 bolts, lock
washers, and flat washers as shown on the front of the
swing plate. Tighten to 30 Nm.
C. Use the wrench to install the third bolt, lock washer, and
flat washer on the side as shown. Tighten to 30 Nm.
C
B
A
1
3
2
30 Nm
30 Nm
