VX-127 O
PERATING
M
ANUAL
11
The
VX-127
may be used for Packet operation, using the optional
CT-91
Microphone
Adapter (available from your Yaesu dealer) for easy interconnection to commonly-avail-
able connectors wired to your TNC. You may also build your own cable, using a four-
conductor miniature phone plug, per the diagram below.
The audio level from the receiver to the TNC may be adjusted by using the
VOL
knob, as
with voice operation. The input level to the
VX-127
from the TNC should be adjusted at
the TNC side; the optimum input voltage is approximately 5 mV at 2000 Ohms.
Be sure to turn the transceiver and TNC off before connecting the cables, so as to prevent
voltage spikes from possibly damaging your transceiver.
When you are operating on Packet, switch the Receive Battery Saver OFF, as the “sleep”
cycle may “collide” with the beginning of an incoming Packet transmission, causing your
TNC not to receive the full data burst. See page 62 for details regarding Battery Saver
setup.
I
NTERFACE
OF
P
ACKET
TNC
S
Summary of Contents for VX-127
Page 37: ...VX 127 OPERATING MANUAL 35 NOTE...
Page 47: ...VX 127 OPERATING MANUAL 45 NOTE...
Page 58: ...VX 127 OPERATING MANUAL 56 NOTE...
