FCC ID: K6630083220
IC ID: 511B-30083220
Operating Manual
10/14
Vertex Standard Co., Ltd.
Default: KEY
KEY: Illuminates the LCD/Keypad for 5 seconds when any key is pressed.
4.16.6 SCL (Scan Lamp)
Function: Enable/disable the Scan lamp while paused.
Available Values: ON/OFF
Default: OFF
4.16.4 SCn (Scan Display)
Function: Select the display mode while scanning.
Available Values: nor (Normal)/SPL (Special)
Default: nor (Normal)
nor (Normal): Changes the channel number accordance with scanning
SPL (Special): The channel number does not changed while scanning. However, the
channel number changes to the scan stop channel, when the scanner is stopped.
4.17 CLONNING
The
HX370S
includes a convenient “Clone” feature, which allows the memory and
configuration data from one transceiver to be transferred to another
HX370S
. Here is the
procedure for Cloning one radio’s data to another:
1. Turn both radio off.
2. Connect the Clone Cable between the
MIC/SP
jacks of the two transceivers.
3. Hold
down
the
PRESET
key and then turn on the transceiver. Do this for both
transceivers (the order of switch on does not matter). “cLn” will appear on the display on
both transceivers.
4. On
the
Destination
transceiver, press
MEM
key (“cr” will appear on the LCD).
5. Press
the
16/9
key on the
Source
transceiver; “cS” will appear on the Source radio, and
the data is transferred.
6. If there is a problem during the cloning process, “cE” will displayed. Check your cable
connections and battery voltage, and try again.
7. If the data transfer is successful, the Destination transceiver will return to normal
operation; Turn both transceivers off and disconnect the Clone cable. You can then turn
the transceivers back on, and begin normal operation.
4.18 RESETTING THE TRANSCEIVER’S MICROPROCESSOR
Resetting the microprocessor restores the initial, factory supplied conditions in the
transceiver. These are called the default conditions. To reset the microprocessor, first the
transceiver off. Then while holding the
WX
and
SCAN
keys pressed, turn the transceiver on.
The default conditions are:
• No channel numbers are in memory.
• Channel 16 is the priority channel.
• Channel 16 will be selected when the transceiver is turned on.
• WX channel 01 will be recalled when the
WX
key is pressed.
• Preset Channels are unassigned.
Note:
The above procedure also resets the microprocessor. Perform this procedure if an
operational problem occurs.
5. BATTERY
CAUTION:
To avoid risk of explosion and injury,
FNB-83/FNB-V57IS
battery pack should
only be removed, charged or recharged in non-hazardous environments.
5.1 BATTERY REMOVAL/INSTALLATION
1. Turn the transceiver off.
2. To remove, open the Battery Pack Latch on the bottom of the transceiver, then slide the
