FTA-750/FTA-550 O
perATing
M
AnuAl
56
s
cannIng
o
peratIon
Note
:
When you enable the alarm function at reception of the
weather alert signal via the
COMM SETUP
menu in the
SETUP mode, the last weather channel will be watched
as the every second frequency during a scan.
Example:
when the last weather channel is
162.4 MHz, the radio scans in the following order.
108.000 → 162.400 → 108.025 → 162.400 →
108.050 → 162.400 ...
The frequency of the last weather channel, however,
will not be displayed until the scanner encounters the
weather alert signal.
Scanning the Specified Channels
Among the memory and weather channels, you may
scan only those on which you want to see if a signal
exists.
Marking the channels
1. Set the radio to the MR or WX mode and tune to the
channel that you want to be scanned.
2. Press the [
MENU
] key to display the
MENU
screen.
3. Select
“
FUNC
” on the screen by pressing the [
◄
] or
[
►
] key, and then press the [
ENT
] key.
4. Select
“
SCAN MEM
” on
the screen by pressing
the [
◄
] or [
►
] key, and
then press the [
ENT
]
key.
SCAN MEM
DUAL WATCH
SCAN
SPLIT
LOGGER
OFF
OFF
OFF
OFF
OFF
FUNCTION
The current channel is
marked to be scanned
and the “
MEM
” icon,
which indicates that the
channel is the target
of scanning, will ap-
pear at the right side of
the channel frequency
when the display re-
turns to the MR or WX
mode screen.
133.800
VOL
132.400 Las Vega
BUSY
Los Angeles
MR
MEM
5. Repeat steps 1 to 4 above to mark other channels as
well.
