Page 5
FT-897D O
PERATING
M
ANUAL
I
NSTALLATION
AC power source operation
(requires optional FP-30 AC power supply)
P
OWER
C
ONNECTIONS
For base station installations, Yaesu recommends the use of
the
FP-30
AC power supply, which is designed to clamp
onto the
FT-897D
.
Installation
1. Turn the transceiver’s power off, and disconnect all
cables from the transceiver.
2. Remove the six screws (three screws on bottom side and
rear side), then lift off the bottom cover (Figure 1 and 2).
3. Attach the
FP-30
to the bottom of the
FT-897D
, then
affix it in place with the six screws removed in the above
steps (Figure 3).
4. Connect the 6-pin Molex plug from the
FP-30
to the
INPUT
jack on the rear panel of the
FT-897D
(Figure
4).
5. Make sure that your AC voltage is correct and that the
FP-30
POWER
switch is set to Off; connect the AC
power cable between the
INPUT
jack on the rear panel
of the
FP-30
and a nearby AC wall outlet.
Operation
1. To turn the transceiver on, turn on the
POWER
switch
on the
FP-30
before
turning on the
POWER
switch on
the
FT-897D
.
2. To turn the transceiver off, turn off the
POWER
switch
on the
FT-897D
before
turning off the
POWER
switch
on the
FP-30
.
When you do not use the
FP-30
with the
FT-897D
for a long time, disconnect the AC plug from the AC
wall outlet.
Figure 1
Figure 2
Figure 4
POWER
Switch
Figure 3
AC Input Voltage Selection (U.S.A. Users only)
Ì
Before moving the AC range switch, disconnect the
FP-30
’s AC Power
Cable from the AC line outlet, then wait 10 minutes to allow the power
supply’s electrolytic capacitors to discharge (electrical shock hazard!).
Ì
Peel off the label on the side of the
FP-30
.
Ì
Move the AC range switch to the “115” position for operation from
100-120 VAC, or to the “230” position for operation from 200-240 VAC.
Ì
Always uses the 10 A Fuse in the fuse holder on the rear panel whether
operate on 100-120 VAC or 200-240 VAC. Do not use the improper
fuse.
Warning:
Our Warranty does not cover damage caused by improper supply voltage nor use of an improper fuse.
Peel off the label
