Yaesu FT-757GX II, Technical Supplement

Page: 14 / 70

OU TER C OVER REMOVAL
*LOOSEN ON BOTH SIDES
SLIDE FORWARD
4
RF AND LOCAL UNIT ACCESS
For access to the solder sides of the RF and Local
Units, loosen the screws (marked
*)
on each side
and slid the front panel forward.
To remove the RF Unit, the KEY jack nut must be
removed using a special wrench (see your Yaesu
agent). Disconnect the following plugs from their
corresponding jacks on the RF UNIT: 127/P14,
121/Pos, 129/Pos, 103/Po3, 101/Po1 and l34/Po3·
Remove the 5 screws in the board and the KEY
jack nut. Then note the position of the FWD SET
knob, and remove it (it should be replaced in the
same position).
- 1 1 -