26
FT-2800M O
PERATING
M
ANUAL
Tone Search Scanning
In operating situations where you don’t know the CTCSS tone or DCS code being used by
another station or stations, you can command the radio to listen to the incoming signal and
scan in search of the tone being used. Two things must be remembered in this regard:
¦
You must be sure that your repeater uses the same tone type (CTCSS vs. DCS).
¦
Some repeaters do not pass the CTCSS tone or DCS code; you may have to listen to the
station(s) transmitting on the repeater uplink (input) frequency in order to allow Tone
Search Scanning to work.
To scan for the tone in use:
1. Set the radio up for either CTCSS or DCS Decoder operation (see the previous discus-
sion). In the case of CTCSS, “
TSQ
” will appear on the display; in the case of DCS,
“
DCS
” will appear on the display.
2. Press the Microphone’s [
P3
] key momentarily to start scanning for the incoming CTCSS
or DCS tone/code.
3. When the radio detects the correct tone or code, it will halt on that tone/code, and audio
will be allowed to pass.
4. Press and hold in the [
MHz
(
SET
)] key for one second to lock in that tone/code and exit
to normal operation.
If the Tone Scan feature does not detect a tone or code, it will continue to scan
indefinitely. When this happens, it may be that the other station is not sending any
tone. You can press the Microphone’s
[
P3
]
key to halt the scan at any time.
Tone Scanning works either in the VFO or Memory modes.
A
DVANCED
O
PERATION
CTCSS/DCS O
PERATION
