14
FT-2800M O
PERATING
M
ANUAL
Hi! I’m R. F. Radio, and I’ll be helping you along as you learn the many features
of the FT-2800M. I know you’re anxious to get on the air, but I encourage you to
read “Basic Operation” section of this manual as thoroughly as possible, so you’ll get the
most out of this fantastic new transceiver. Now. . .let’s get operating!
T
URNING
THE
T
RANSCEIVER
O
N
AND
O
FF
1. To turn the transceiver on, press and hold in the
PWR
key
for one second.
When you turn on the
FT-2800M
, the current DC supply
voltage is indicated on the LCD for 2 seconds. After this
interval, the display will switch its normal indication of the
operating frequency.
2. To turn the transceiver off, again press and hold in the
PWR
key for one second.
A
DJUSTING
THE
A
UDIO
V
OLUME
L
EVEL
Rotate the
VOL
control to adjust the receiver volume. Clock-
wise rotation increases the audio output level.
A
DJUSTING
THE
S
QUELCH
S
ETTING
Rotate the
SQL
control just to the point where the noise is si-
lenced and the “
” indicator on the display turns off. If the
SQL
control is set further clockwise, sensitivity to weak sig-
nals is reduced.
A special “
RF Squelch
” feature is provided on this radio. This
feature allows you to set the squelch so that only signals exceeding a certain S-meter level
will open the squelch. See page 20 for details
F
REQUENCY
N
AVIGATION
1) Tuning Dial
Rotating the
DIAL
knob allows tuning in the pre-programmed steps. Clockwise rotation of the
DIAL
knob causes the
FT-2800M
to be tuned toward a higher frequency, while counter-clock-
wise rotation will lower the operating frequency.
Press the [
MHz
(
SET
)] key momentarily, then rotate the
DIAL
knob, to change the frequency
steps to 1 MHz per step. This feature is extremely useful for making rapid frequency excursions
over the wide tuning range of the
FT-2800M
. Instead of pressing the [
MHz
(
SET
)] button, you
may also press the [
A
] key on the Microphone’s keypad to engage tuning in 1 MHz steps.
B
ASIC
O
PERATION
PWR
MHz
PWR
MHz
PWR
MHz
