6
8. Replace the rubber cap to the forward left of the top case.
9. To continue installing DSP Firmware, proceed to step 4 of “
Installation of the DSP firmware
” on the
next page.
10. If not using the LAN-UNIT for IMRS (Internet-linked Multi-site Repeater System) function, this completes
the RX-UNIT firmware installation process.
11. Through the hole at the rear of the top case, move the slide switch (S6013) toward to the “
LAN
” side (“Left”
side as shown in figure).
Switch (S6013)
LAN
12. Replace the rubber cap at the rear of the top case.
This completes the RX-UNIT firmware installation process.
Summary of Contents for DR-2X
Page 9: ......