Speakerphone
Battery Operations
IMPORTANT: Before installing the YD-V36, make sure:
• Vehicle is parked in a safe area
• Car engine is OFF
• Emergency brake is set
Your YD-V36 may be installed in your
vehicle’s cup holder.
• Make sure that the device is secure
and firmly placed in the cup holder
• Adjust the angle of the speaker
and the microphone for better
performance
• Place the microphone extension
behind the speakerphone and
adjust the angle accordingly for
maximum sound quality
12V/24V Car Charger
Installations
The YD-V36 is equipped with a built-in rechargeable
Li-Polymer battery, which provides better than normal phone
battery life span.
NOTE: The YD-V36 Speakerphone battery comes pre-charged,
however the battery will discharge if the device is not used for
a long time.
A. Low Battery Indication
Recharge battery when:
• Indicator light turns red and flash 4 times every 30 seconds
B. Charging
Follow the steps below when charging the YD-V36
Speakerphone:
• Insert the charging cable to the charging port of the YD-V36
• Plug the cable to the vehicle’s 12V power port
• When the device is in charging mode, the red indicator light
is on indicating that charging is in progress
NOTE:
• Standard charge time is around 2.5 hours
• Battery indicator light will turn off once fully charged
• Disconnect the charger
cable once the battery is
fully charged
IMPORTANT: Do not leave the
YD-V36 Speakerphone charging in
the vehicle unattended.
NOTE:
• To charge the unit at home, use a 12V DC to AC convert
• Do not attempt to remove the battery from the YD-V36
Microphone
Extension
NOTE: The microphone extension is optional. Depending on the
location of the cup holder, the microphone extension may increase
mic sound quality.
Package Content
6