Page 15 of 45
Figure 2.7.: Home page of the switch web server
It could be that you need to adjust the IP configuration of the calling host to reach
the web server with the switch. Also pay attention to existing firewalls that may
block the access.
3.
Functions
3.1.
Basic Settings
This chapter describes the basic functionality of the switch. To learn more about the
management functions of the switch, we recommend that you go to chapter 4.
3.1.1.
Protocol
•
Data Transfer
: The Ethernet Ports of the ether
RAIL
SM-Series support the
following Ethernet-Protocols due to the IEEE-802.2- Specification.
–
100BASE-TX/FX Full Duplex 100 MBit/s,
–
100BASE-TX Half Duplex 100 MBit/s,
–
10BASE-T Full Duplex 10 MBit/s,
–
10BASE-T Half Duplex 10 MBit/s.
The settings of the protocols are fixed as soon as the switch is powered up. The
transfer rate can be set separately for each port, while the settings for duplex mode
apply to all ports. In addition, auto-negotiation can be separately set for each port.
The switch has mechanisms to select the protocol with the best performance
between the link partners: