— 15 —
IV. Configuration with External Button
Configuration with the external button is limited and allows to change volume and set Device operation
mode (see the Section II). To enter configuration mode:
•
in MOB button mode: quickly press the button 5 times;
• in other modes: hold the button for 5 seconds.
Device confirms entering of the configuration mode with a 5-second long signal of the external LED. Press
the button once during that LED signal to enter mode programming, or wait until the Device enters volume
programming after that LED signal.
In mode programming, external LED will continuously flash, depending on the current mode:
•
1 short flash: MOB button mode;
•
2 short flashes: digital switching mode;
•
3 short flashes: engine alarm mode.
In the volume programming:
•
1 short flash: 1% of volume;
•
2 short flashes: 20% of volume;
•
3 short flashes: 40% of volume;
•
1 long flash: 60% of volume;
•
2 long flashes: 80% of volume;
•
3 long flashes: 100% of volume.
Press the button to cycle between modes or volume levels.
To apply settings, do not press the button for 10 seconds, Device will save current settings and return to
normal operation mode.
