No.
Item
Qty
1
XZENT X-F270 device
1
2
IR remote control
1
3
Two-part metal mounting frame
1
4
Self-tapping Philips screws
4
5
10PIN adaptor cable for 4.2 channel line-out
1
6
6PIN adaptor cable for A/V monitor-in
1
7
12PIN adaptor cable cam power + video-in
1
8
4PIN adaptor cable A/V monitor-out
1
9
Microphone with 3m cable extension and 3.5 mm jack
1
10
Parking brake connection cable
1
11
Main wire harness ISO/DIN
1
12
SWC interface adaptor
1
13
FM antenna adaptor ISO/DIN
1
14
GPS-antenna with 90° angled connector and 3 m cable extension
1
15
Doublesided 3M self-adhesive pad for GPS antenna
1
16
Main device manual for X-F270
1
17
USB extension cable with 80 cm length (gray / black)
2
FIAT DUCATO III
COMPATIBILITY LIST
Model
Model Version
Model Year
Fiat Ducato III
250/251
2006 - 2011
Fiat Ducato III
250/251
2011 - 2014
Fiat Ducato III
250/251
as of 2014
Citroën Jumper II
250/250D/250L
as of 2006
Peugeot Boxer II
250/251
as of 2006
CAUTION
-
The installation of the XZENT system should be carried out by an authorized installer. Specific knowledge and tools are required to do the installation.
Incorrect installation can cause damage to the vehicle and the XZENT system.
-
Correct functioning can only be guaranteed when you use the XZENT original accessories included in the kit or optionally available. The XZENT system and
the original accessories must under no circumstance be modified or altered in any way. Inappropriate actions can cause damage to the vehicle and the XZENT
system.
NOTE
-
The target vehicle must factory configured with preinstallation for a radio system. The XZENT system is not compatible with vehicles that are equipped with
an OE radio or OE navigation system from the factory.
-
This device installation manual applies to vehicle platforms appearing in the above compatibility list, and in a condition as offered by the respective vehicle
manufacturer. Deviating equipment and specific adjustments to battery-, charging systems and power harness layout implemented by the given motorhome
manufacturer brand are not taken into account in these installation instructions. Please contact the relevant motorhome manufacturer.
-
The XZENT system is equipped with an integrated DAB+ receiver. To make use of this you will need a suitable DAB antenna (not included in kit) that must be
connected to the XZENT system. If vehicle is equipped with ex-work OE DAB antenna, a FAKRA> SMB adapter is required for connection.
-
In order to obtain better radio reception, it is recommended to equip the vehicle with an active antenna system (FM / DAB).
-
If the target vehicle is equipped with a resistor based multifunction steering wheel, no additional accessories are needed to support the steering wheel
remote control functions.
-
Software updates to the XZENT system are installed with a USB memory device. Therefore when fitting the system make sure that the USB connection of the
XZENT system will still be accessible later (installation of USB extension cable).
-
If you have questions or problems relating to the XZENT system, please contact the dealer from whom you purchased it.
THE KIT INCLUDES
TOOLS REQUIRED
- Torx screwdriver T25
- File
- Phillips screwdriver
- Release tool made of plastic
- Fabric tape
- Hand saw or equivalent tool