XYZ Printing da Vinci Jr. WiFi Pro, Quick Manual

Page: 13 / 70

P 13 HD23FJPW1A7
da Vinci
Jr. WiFi Pro
OPEN MODE
For da Vinci Jr. Pro series / da Vinci Super ( Remove EEPROM Chip )
For da Vinci 1.0 Pro/da Vinci 1.0 Pro 3-in-1
XYZprinting’s Pro series 3D printers support different filament chips. If you have multiple 3D printers at the same time, but only
have one type of filament chip in your hand, you can refer to the instruction of the Open Filament section in User Manual and
load the filament directly.
Before printing, you can select the filament material in the XYZprinting slicing software, in this way, you can apply the default
setting of the material and start printing.
Open the filament box and pick out the filament spool.
Instructions :
• Please refer to the Open Filament section in the User manual.
① Please secure the filament by using the holder first.
② Insert the filament into the feed port. Open the release arm so that the front tip of the filament can be properly inserted into the
feed module.
Instructions :
• Please refer to the Open Filament section in the User manual.
1 2
OPEN MODE