6
XYZ Machine Tools
ProtoTRAK RX CNC control, Safety and Quick Start Guide
Tap the CHECK SYSTEM soft key and, for lathes, enter the maximum (safe) spindle speed based on
chuck rating and/or job setup and press ABS SET
The machine will always power up in an Estop condition, Press the POWER Reset hard key and hold it
for a few seconds, until the white LED comes on, when you are ready to start moving the machine.
Shutting down the ProtoTRAK RX CNC
Important:
The system must be turned off properly or you may lose unsaved data such as
programs or certain machine configurations. The SHUT DOWN soft key will initiate the
process of shutting down safely. When the screen goes blank, turn the power switch at the
back of the electrical cabinet to the Off position.
First close any Fly Out Windows that are open. We also recommend that you complete any prompted
activity, such as programming an Event. Press the BACK hard key repeatedly until you get to the
screen shown above.
The ProtoTRAK control should be shut off at a minimum every few days. Failure to reboot may cause
the control to run slowly. Use the SAVE TEMP feature prior to shut down to save your current
positions, tool information and program.
If the screen does not go blank after the RX software closes, use the on-screen keyboard or an
external keyboard to shut down Windows in the normal way (do not switch off power if Windows is
still running).
Please refer to the Operating Manual for full operating instructions.
Maintenance
Please refer to the maintenance schedule on the machine or in the service manual for important
maintenance activity.
