Controls and Indicators
Figure 2 shows the location and purpose of all controls and LED indicators on the Network 9000
Redundant AC Power Input Module.
11/5230V~
12/6A
50-60Hz
ON
OFF
CS
119R
I/O Connector
Redundant 08-00-87-xx-xx-xx
Power Cord
Connector
On/Off Switch
Control Store
Run LED
Control Store
Reset Switch
I/O Connector Location
(Supports Network 9000 Type 1
communication options.)
Ethernet Address Label
Figure 2. Redundant AC Input Module Controls and Indicators.
Installation Notes
The power input modules and power supply modules are removable. When configured as a
redundant system, individual power input modules and power supply modules may be "hot
swapped" without bringing the unit down. Generally, you install power supply modules and
Redundant AC Power Input Modules using the standard Network 9000 installation and
removal procedures, that are described in Chapter 3 of the Network 9000 Installation Guide. (If
you are not familiar with these installation procedures, refer to the Network 9000 Chassis
Hardware Installation and Maintenance Guide.) This section describes some minor
differences from procedures, that are due to the use of Redundant AC Power Input Modules.
Safety Considerations
Although only low voltages are present on exposed pins , high voltages also exist within the
Network 9000 Chassis
☞
Do not insert any item, such as a screwdriver (for example to
straighten out a bent pin, etc), into the inside of the chassis
while power is on as damage to the equipment can occur.
Use caution when installing or removing modules. (Do not remove the Network 9000 midplane.)
All modifications or upgrades to the midplane must be made at the factory.
3