PolluCom
®
F/S C Heat/Cooling Meter
Installation and operating instructions
M H 1500 INT, Page 12
Checksum
High-resolution energy
display *
High-resolution volume
display *
Back to the selection menu
(press and hold for 2
seconds)
7.5 Rate function level (L 5)
All display elements are marked with the letters
"CTRL". The rate functions can be set and
controlled here.
Error message
(only in case of an error)
Set message interval for
flow and energy *
Efficiency in the current
notification interval *
Flow in the current
notification interval *
Setting of rate 1 start time
(if activated, for rate with
start and end time) *
Setting of rate 1 end time
(if activated, for rate with
start and end time) *
- Set temperature
difference
- Set temperature limit in
the colder pipe
- Set temperature limit in
the warmer pipe
- Set flow limiter
- Limit of thermal output
(if enabled, for limited
value rate) *
If rate is not used, "off" is
displayed *
Switchover temperature
for cold metering (if
enabled) *
Changeover point for
negative temperature
difference cold metering
(if activated) *
Correction factor for anti-
freeze mixtures *
Back to the selection
menu (press and hold for
2 seconds)
7.6 Parameter level (L 6)
Each display element is marked with a tool symbol.
This level is password protected. The password
corresponds to the last three digits of the eight-digit
serial number on the meter housing. "000" appears
first. Then press and hold the key for approx. 2
seconds; the left digit starts flashing. Change the
value of the flashing digit by pressing the key
continuously. As soon as the required value is
displayed, release the key. A short keystroke
confirms the set value and advances to the next
digit. Set this value in the same way. After setting
the last digit, the level is unlocked.
Now the required menu items can be selected by
briefly pressing the key; the values are set in the
same way as the password entry.
