Xylem ecocirc XL, Instruction Manual

Page: 17 / 20

Cause Solution
Tripped circuit breaker or
ground-fault protection
device or the circuit break-
er.
Reset power supply circuit breaker and
determine cause for overload.
If display shows "ALOC",
the rotor unlocking func-
tion is in progress.
The procedure, in the attempt to unlock
the rotor can produce noise and vibration.
Wait for the procedure to finish (approxi-
mately 30 seconds).
The pump starts but the thermal protection is triggered after a short
time
Cause Remedy
Incorrect wiring size or circuit break-
er rating not suitable for motor cur-
rent.
Check and replace the compo-
nents as necessary.
Thermal overload protection due to
excessive input.
Check the pump working con-
ditions.
Missing a phase in the power supply. Verify continuity and ensure
proper wiring connections.
The pump is noisy
Cause Remedy
Not thoroughly vented. Switch off the pump and after 30 seconds
switch on again to restart the automatic
air-venting procedure.
Cavitation due to insuffi-
cient suction pressure.
Increase the system suction pressure
within the admissible range.
Foreign objects in pump. Clean the system.
Worn out bearing Replace pump.
9 Other Relevant Documentation or
Manuals
9.1 Embedded Software and Driver Software
License Agreement
With the purchase of the product, the terms and conditions of the li-
cense for the software embedded on the product are considered ac-
cepted. For more information see license condition on www.bellgos-
sett.com
FCC Statement — USA only (Federal Communications Commission)
This device complies with Part 15 of the FCC Rules. Operation is sub-
ject to the following two conditions:
1. this device may not cause harmful interference and
2. this device must accept any interference received, including inter-
ference that may cause undesirable operation.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that in-
terference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate
the equipment.
10 Product warranty
Commercial warranty
Warranty. For goods sold to commercial buyers, Seller warrants the
goods sold to Buyer hereunder (with the exception of membranes,
seals, gaskets, elastomer materials, coatings and other "wear parts" or
consumables all of which are not warranted except as otherwise pro-
vided in the quotation or sales form) will be (i) be built in accordance
with the specifications referred to in the quotation or sales form, if such
specifications are expressly made a part of this Agreement, and (ii) free
from defects in material and workmanship for a period of eighteen (18)
months from the date of installation or thirty-six (36) months from the
date of shipment (which date of shipment shall not be greater than af-
ter receipt of notice that the goods are ready to ship), whichever shall
occur first, unless a longer period is specified in the product documen-
tation (the “Warranty”).
Except as otherwise required by law, Seller shall, at its option and at no
cost to Buyer, either repair or replace any product which fails to con-
form with the Warranty provided Buyer gives written notice to Seller of
any defects in material or workmanship within ten (10) days of the date
when any defects or non-conformance are first manifest. Under either
repair or replacement option, Seller shall not be obligated to remove
or pay for the removal of the defective product or install or pay for the
installation of the replaced or repaired product and Buyer shall be re-
sponsible for all other costs, including, but not limited to, service costs,
shipping fees and expenses. Seller shall have sole discretion as to the
method or means of repair or replacement. Buyer’s failure to comply
with Seller’s repair or replacement directions shall terminate Seller’s
obligations under this Warranty and render the Warranty void. Any
parts repaired or replaced under the Warranty are warranted only for
the balance of the warranty period on the parts that were repaired or
replaced. Seller shall have no warranty obligations to Buyer with re-
spect to any product or parts of a product that have been: (a) repaired
by third parties other than Seller or without Seller’s written approval;
(b) subject to misuse, misapplication, neglect, alteration, accident, or
physical damage; (c) used in a manner contrary to Seller’s instructions
for installation, operation and maintenance; (d) damaged from ordina-
ry wear and tear, corrosion, or chemical attack; (e) damaged due to ab-
normal conditions, vibration, failure to properly prime, or operation
without flow; (f) damaged due to a defective power supply or improper
electrical protection; or (g) damaged resulting from the use of accesso-
ry equipment not sold or approved by Seller. In any case of products
not manufactured by Seller, there is no warranty from Seller; however,
Seller will extend to Buyer any warranty received from Seller’s supplier
of such products.
THE FOREGOING WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY
AND ALL OTHER EXPRESS OR IMPLIED WARRANTIES, GUARANTEES,
CONDITIONS OR TERMS OF WHATEVER NATURE RELATING TO THE
GOODS PROVIDED HEREUNDER, INCLUDING WITHOUT LIMITATION
ANY IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, WHICH ARE HEREBY EXPRESSLY DIS-
CLAIMED AND EXCLUDED. EXCEPT AS OTHERWISE REQUIRED BY
LAW, BUYER’S EXCLUSIVE REMEDY AND SELLER’S AGGREGATE LIA-
BILITY FOR BREACH OF ANY OF THE FOREGOING WARRANTIES ARE
LIMITED TO REPAIRING OR REPLACING THE PRODUCT AND SHALL
IN ALL CASES BE LIMITED TO THE AMOUNT PAID BY THE BUYER FOR
THE DEFECTIVE PRODUCT. IN NO EVENT SHALL SELLER BE LIABLE
FOR ANY OTHER FORM OF DAMAGES, WHETHER DIRECT, INDIRECT,
LIQUIDATED, INCIDENTAL, CONSEQUENTIAL, PUNITIVE, EXEMPLARY
OR SPECIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LOSS OF
PROFIT, LOSS OF ANTICIPATED SAVINGS OR REVENUE, LOSS OF IN-
COME, LOSS OF BUSINESS, LOSS OF PRODUCTION, LOSS OF OP-
PORTUNITY OR LOSS OF REPUTATION.
Limited consumer warranty
Warranty. For goods sold for personal, family or household purposes,
Seller warrants the goods purchased hereunder (with the exception of
membranes, seals, gaskets, elastomer materials, coatings and other
"wear parts" or consumables all of which are not warranted except as
otherwise provided in the quotation or sales form) will be free from de-
fects in material and workmanship for a period of eighteen (18) months
from the date of installation or thirty-six (36) months from the product
9 Other Relevant Documentation or Manuals
ecocirc ® XL INSTRUCTION MANUAL 15