2
1
3
4
5
6
7
8
9
11
13
14
16
17
18
10
12
15
1. Impeller
2. Vent Plug
3. Volute
4. Volute Gasket
5. Coverplate
6. Seal Assembly
7. Bearing Frame
8. Shaft
9. Support Foot
10.Support Foot Capscrews
11.Slinger
12.Bearing Frame Capscrews
13.Shaft Sleeve
14.Impeller Key
15.Impeller Washer
16.Impeller Lock Washer
17.Drain Plug
18.Impeller Capscrew or Nut
6.4.1.2 Assemble the single mechanical seal (e-1510-S)
1. Lubricate the shaft sleeve and seal cap with soapy water.
Do not use a petroleum lubricant.
2. Insert a stationary seal with an O-ring into the seal cap and slide it onto the shaft.
3. Replace the seal cap gasket.
4. Slide the rotating portion of the seal assembly onto the shaft sleeve and lock it in
place.
ID seal size
Distance between collar and impeller end of the shaft sleeve
1-1/4 in. (3.175 cm)
1-13/32 in. (3.571 cm)
1-5/8 in. (4.128 cm)
1-1/4 in. (3.175 cm)
2-3/8 in. (6.033 cm)
1-1/4 in. (3.175 cm)
5. Assemble the coverplate onto the bracket.
6. Tighten the capscrews according to the Capscrew torque table.
7. Attach the seal cap to the coverplate.
8. Tighten the hex nuts on the seal cap bolts according to the Capscrew torque table.
6 Maintenance
30
Series e-1510 INSTRUCTION MANUAL
Summary of Contents for Bell & Gossett e-1510 Series
Page 1: ...INSTRUCTION MANUAL P2001406 Rev E Series e 1510...
Page 2: ......
