en – Original Instructions
Installation, Operation and Maintenance Manual
7
WARNING: Risk of electric shock
Connect only to a branch circuit protected by a ground-fault circuit-interrupter
(GFCI). Contact a qualified electrician if you cannot verify that the circuit is
protected by a GFCI.
The unit must be connected only to a supply circuit that is protected by a
ground-fault circuit-interrupter (GFCI). Such a GFCI should be provided by the
installer and should be tested on a routine basis. To test the GFCI, push the test
button. The GFCI should interrupt power. Push the reset button. Power should
be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If
the GFCI interrupts power to the pump without the test button being pushed, a
ground current is flowing, indicating the possibility of an electric shock. Do not
use this pump. Disconnect the pump and have the problem corrected by a
qualified service representative before using.
NSF/ANSI 61 limitation
CAUTION:
Do not allow the temperature above 140 °F (60 °C) in systems circulating drinking
water.
California Proposition 65
WARNING: California Proposition 65 warning
This product contains chemicals known to the state of California to cause cancer
and birth defects or other reproductive harm.
Qualified personnel
WARNING:
This unit must be used only by qualified users. Qualified users are people able
to recognize the risks and avoid hazards during installation, use and
maintenance of the unit.
General safety rules
•
Always keep the work area clean.
•
Pay attention to the risks presented by gas and vapors in the work area.
•
Avoid all electrical dangers. Pay attention to the risks of electric shock or arc flash hazards.
•
Always bear in mind the risk of electrical accidents and burn injuries.
Safety equipment
It is recommended to use the proper safety equipment within the work area:
•
Hard hat
•
Safety goggles
•
Protective shoes
•
Protective gloves
•
Hearing protection
