Setup
, Configuration and Calibration
Turb PLUS 2000
100193 Rev 0 ba77254e01 11/2020
33
6.2.8
Display Resolution - Setting Resolution
The instrument is equipped with the ability to display several levels of resolution. The instrument
can display up to four digits to the right of the decimal place for turbidity readings below 10 NTU.
The default setting is 000.00 If the last digit or two is not stable, adjust the resolution to hide
these insignificant digits.
To change the Resolution:
1. Enter the
CONFIG
mode by pressing the
or
buttons until the arrow beside
CONFIG
is illuminated,
then press the
button.
2. Press the
button to move to the next menu until
RES
is displayed, then press the
button.
3. Change the resolution by pressing the
or
button.
4. When the desired digit resolution has been selected, press the
button to accept it and move to the
next menu or the
button to exit and return to
AUTO
.
6.2.9
LCD Brightness - Setting the LCD backlight brightness
The LCD backlight brightness may need to be adjusted. This is of particular interest if multiple
instruments are located in the same area and it is desired for the entire group to have the same
appearance. Ten levels are available. The default brightness is 8.
To adjust Backlight Brightness:
1. Enter the
CONFIG
mode by pressing the
and
buttons until the arrow beside
CONFIG
is
illuminated, then press the
button.
2. Press the
button to move to the next menu until
BRT
is displayed.
3. Change the brightness by pressing the
or
button.
4. When the desired brightness has been selected, press the
button to accept it and move to the next
menu or the
button to exit and return to
AUTO
.
