Chapter 2 - Testing
2-1
Chapter 2 – Testing
Introduction
Diagnostic tests are provided to verify operation of 9450 system hardware functions. If
any of these tests fail, either you do not have the correct default setting or there is a sys-
tem failure. Check the default settings and run the tests again. If there is a failure, contact
Xycom’s Product Repair & Customization (PR&C) Department (see Chapter 5).
Note
Unexpected failures may occur if Xycom diagnostics are run with device drivers or
memory resident programs installed on the system. Remove these before running any
diagnostics tests.
Checking System Setup
You want to ensure that the Setup Menu is configured properly (factory-set configura-
tion). The way you access the Setup Menu depends on the CPU board installed in your
system.
Phoenix BIOS
If the CPU board has a Phoenix BIOS, press
F
2 when prompted to enter the Setup Menu.
Make the necessary changes by following the on-screen directions. General instructions
for navigating through the Setup screens are described below:
•
ÅÆ
select a menu. Once you’ve selected a menu, press
ENTER
to validate your se-
lection.
•
ÇÈ
select an item in the menu. Once you’ve selected an item, press
ENTER
to vali-
date your selection.
•
ESC
exits the menu. You are prompted to save changes.
•
+/-
change values.
•
ENTER
selects a sub-menu.
•
F
9
automatically configures the system with the default values. These values are de-
fined by the system configuration and the values are set in the Setup Menu.
•
F
10
loads previous values.
