9450 Industrial PC/AT Computer System
1-4
Note
If a touch screen has been factory installed, there is an AT adapter board plugged into
the backplane in slot 5. Connect the 9-pin cable from the monitor side to the 9-pin con-
nector in slot 5.
To prepare the system for use, perform the following steps.
1.
Connect the video cable to the 15-pin connector on the CPU board.
2.
Connect the PWR/Key 15-pin cable to the PWR/Key female receptacle located
above the power receptacle.
3.
Attach the power cord from the monitor to the power receptacle. Attach the power
cord power receptacle to a properly grounded 115/230 VAC, 50/60 Hz outlet. Attach
the power cord to the lower power receptacle.
4.
Connect the 9-pin DB connector which is attached to the touch screen adapter board
located in slot 5 (optional feature).
5.
Turn on power to the unit by pressing the ON/OFF switch. The system will boot up at
the C: prompt if MS-DOS is properly installed on drive C.
6.
Set the contrast and brightness controls on the back panel to the desired levels.
7.
Install the application software via drive A, located behind the access door on the
front panel.
