Xyclop user manual for 16 channel network video recorder
------------------------------------------------------------------------------------------------------------------------------------------
131
Steps:
1.
Enter the Advanced settings interface, as shown in the Figure 9. 31.
Configuration > Remote Configuration > Network Settings > Advanced
2.
Check the checkbox of the
Enable Telnet
.
3.
Click the
Save
button to save the setting.
4.
You can open the Command Prompt window in your PC, and input “telnet
IP Address
” to connect with the
NVR, as shown in the figure below.
Example:
If the IP address of the NVR is 192.0.0.64, you can input “telnet 192.0.0.64” and then press Enter to connect
to the NVR.
Figure 9. 33
Connect to NVR
The telnet function turns invalid after the device shutting down or rebooting, you have to enable it again if
required.
