XVision XPR16P, Quick Manual

Page: 5 / 12

5
Basic Setup
Enter the OSD main menu and setup some basic configuration of the DVR. The basic configuration
can be set via either the DVR or DVR Remote , the remote software.
Enter OSD Main Menu:
•
Press MENU to enter the OSD main menu.
•
Enter username and password. The default username and password is admin and 1234 .
•
Press MENU again to quickly input the default username “ admin ”.
•
It is strongly suggested to change the password to prevent unauthorized access.
Date / Time Setting:
Follow steps below to setup date/time before the recording starts. Refer to the User’s Manual for
advanced setup of Time Sync function.
•
Select < Date/Time > in System Setup menu.
•
Select the date and time using LEFT/RIGHT keys; then adjust the value using UP/DOWN keys.
•
The new date and time settings take effect after the changes are confirmed.
Language Setting:
If users wish to change language of the DVR system, follow the steps below.
•
Select < Language > in System Setup menu and press ENTER .
•
Press the UP/DOWN keys to select the desired language.
Network Setup
Configure the LAN setup when users plan to use a LAN, WAN, or Internet connection without a
dialup modem. It requires an Ethernet connection to a network. The default ID of the Premium
H.264 DVR must be changed to avoid network conflicts.
•
From OSD main menu, select < System Setup > < Network Setup >, set the < LAN Select >
item to < LAN > or < PPPoE > according to the network application, and enter < LAN Setup >.
•
For DHCP users, set the DHCP to < ON >. The IP address, Netmask, Gateway and DNS settings
are retrieved from network servers. DHCP is dynamic that the settings change from time to time.
•
For Non-DHCP users, set the DHCP to < OFF >. IP address, Netmask, Gateway and DNS
settings must be set. Please obtain the information from the network service provider.
•
To change the IP address, Netmask, Gateway and DNS value, press UP/DOWN keys to move
the cursor to the item. Use LEFT/RIGHT keys to access each section of the value and press
ENTER , then change the value using UP/DOWN keys.
•
PPPoE users must set the < PPPoE Account >, < PPPoE Password > and < PPPoE Max Idle >
as well.
•
When the settings are complete, press ENTER to confirm and save the settings; or ESC to
abort.