Input Voltage:
18V
Battery Capacity:
1.5Ah Li-Ion
Chuck Size:
10mm
No Load Speed:
0-700/min
Torque Settings:
21
Max. Torque:
16Nm
Charge Time:
3-5hours
Tool Weight:
1.1kg
SPECIFICATIONS
USING YOUR
DRILL DRIVER
DRILL DRIVER
OPERATION
OPERATING TIPS
Installing a Bit Into Your Drill
1. Rotate the chuck collar anti-clockwise to open the
chuck
2. Insert the drill bit, making sure it is centred in the
chuck
3. Tighten the chuck by turning the collar clockwise.
4. Pull on the bit to ensure it is firmly secured.
Removing a Drill Bit
1. Rotate the chuck collar anti-clockwise to open the
chuck
2. Remove the bit from the drill chuck.
Forward Reverse Selector
1. For forward rotation, push the fwd/rev selector
towards the left side of the tool.
2. For reverse rotation, push the fwd/rev selector
towards the right side of the tool.
Variable Speed Trigger
1. To start drilling, squeeze the variable speed trigger.
2. To stop drilling, release the trigger
Note: The more the variable speed trigger is depressed,
the faster the drill will rotate.
Drill Driver Torque Settings
1. Rotate the torque collar on your drill driver to select
the desired setting.
Note: Selecting a higher torque setting will allow the
drill to use more torque to drive the screw in or out. To
prevent damaging the screw head, it is recommended
to start at a low torque setting and increase when
necessary.
1. Depress and release the variable speed trigger to
ensure it is not locked.
2. Check the forward/reverse selector is in the desired
setting.
3. Ensure the workpiece is secured to stop it turning
whilst drilling or driving.
4. Hold the tool firmly and then press the variable speed
trigger.
5. Once complete, release the variable speed trigger.
Note: Do not force the tool or apply side pressure to
elongate the hole. Let the tool do all the work.
WARNING!
Ensure the tool is turned off
and disconnected from the power supply
before performing any of the following
operations.
This tool is intended for use in a DIY (Do It Yourself)
context or for hobbyist purposes. It is not built for
continuous daily use in a trade or professional capacity.
Before using the machine, carefully read these
instructions, especially the safety rules to help ensure
that your machine always operates properly.
Before attempting to operate the machine, familiarise
yourself with the controls and make sure you know how
to stop the machine quickly in an emergency.
Save these instructions and the other documents
supplied with this machine for future reference.
Charging Your Battery
1. Plug the charging jack into the battery pack from the
top.
FIG. A
2. Connect the charging adaptor to the power supply.
3. The red battery light will illuminate indicating the
battery is charging.
4. Once the battery is charged, the green battery light
will illuminate.
Fitting the Battery Pack
1. Slide the battery into the base of the tool until it clicks
into place.
FIG. B
2. To remove the battery, press and hold the battery
release tab down then remove the battery.
4
CAUTION:
Do not handle drill bits or other
accessories without gloves as they are sharp
and can become hot after use.
WARNING!
The power supply for this
charger should be protected by a residual
current device (rated at 30mA or less).
