XtremeAIR XA41, Maintenance Manual

Page: 156 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page 10 Page date:
Chapter 32 25.09.2018
5 Do a functional test as follows: Push the control stick forward. The lock must disconnect. The
tail wheel must move freely when the top of the control stick is approximately 25 mm (1 inch)/
aft of the forward stop.
Figure 32-7: Elevator lifted 90mm for adjustment of the tail wheel lock.
32-40-00 WHEELS AND BRAKES
This section gives information on the wheels and the brakes for the maintenance personnel.
It includes inspections, removal, servicing, refinishing and installation.
32-40-01 Wheels
Main wheels:
Beringer 5.00-5 wheels with 5.00-5 10ply tires.
To disassemble the main wheel assembly from the main wheel strut of the main landing
gear:
1 Remove the main landing gear strut, refer to chapter 32-10-00.
2 Remove the axle split pin and the axle nut from the external side of the wheel axle.
3 Remove the main wheel.
4 Install the main wheels in the opposite sequence.
For maintenance of the wheels and brakes, refer to the manufacturer’s maintenance and
overhaul manual BRG-ALTP-02 MM-ETSO-007.