www.XtremeAirUsa.com
PAGE
7
C. INSTALL OIL TUNNEL & BAFFLE FILTER
1. OIL TUNNEL
2. BAFFLE FILTERS:
.
RANGE HOOD OPERATION
Install baffle filters; refer to Figure B on the left for the following three steps:
1.
Angle baffle filter toward back of hood.
2.
Lift a baffle filter up above horizontal level.
3.
Slide forward into slot behind the front of hood.
To remove the baffle, please reverse the process.
Drop oil tunnel into recess support near rear of hood. Refer to
below figure A
5. From inside of the hood, place screws into the exact center of
each knockout holes (4) and secure to cabinet bottom. Finish
tightening all screws until secure. Be careful when using electrical
screwdriver, damage to the range hood may occur. Figure 6
7.
Secure the hood by using 1.5” – 2.0” wood screws (the screws
are not provided) screw through the back of hood to the
studs (use stub finder to find the stud. Figure 7
CAUTION: Make certain the range hood is secure before
releasing
!
8.
Connect the exhaust on the hood to the ductwork above. Use
aluminum tape to make all joints secure and all tight
Figure 7
Figure A:
Oil Tunnel Side View
Figure B: Baffle Instllation Side
