Xtreme EX-1724, Installation Manual

Page: 12 / 19

P. 12
Installation Guide
OPTION 2* Enabled
OPTION 3 Enabled
MODE 3 *indicates default setting
FUNCTION 1 – NA
OPTION 1 n/a
OPTION 2* n/a
OPTION 3 n/a
FUNCTION 2 – AUX 3 / Zone 3 output
OPTION 1 Trunk output when
TRUNK
button pressed for 3-sec while Ignition is OFF
OPTION 2* Constant while
TRUNK
button is pressed
OPTION 3 Trunk output with Disarm / Rearm pulses.
FUNCTION 3 – AUX 2 output
OPTION 1 Constant while pressed
(
LOCK
&
UNLOCK
pressed simultaneously, or
START
in Safe Start Mode.)
OPTION 2* Toggle
ON / OFF
with timeout up to 30 seconds
OPTION 3 Toggle
ON
/ toggle
OFF
with timeout up to 60 seconds
OPTION 4 Priority Door Access
FUNCTION 4 – AUX 1 output
OPTION 1 Horn Confirmation on 2
nd
press of the
LOCK
button
OPTION 2* Priority Door Access
OPTION 3 Horn Confirmation on first press of the
LOCK
button
FUNCTION 5 – External Trigger Sense
OPTION 1 Zone 3 (Trunk pin) rearm (sends a Disarm pulse before Trunk opening and
rearms 4 sec. after the Trunk is closed)
OPTION 2* Engine
START / STOP
OPTION 3 Key Sense
OPTION 4 Smart Ignition Lock
Horn Honk Timing (Optional)
1. Make sure that Mode 3 Function 4 Option1 or Option 3 is activated.
2. FLASH the Hood Pin Switch
Before the 20 seconds have passed,
3. Press and hold the Brake Pedal.
Press the
START/STOP
and
UNLOCK
buttons simultaneously on the Transmitter.
The Horn will Honk 5 times.
4. Release the Brake Pedal.
5. To change the timing:
To increase the Horn Honk by 3 ms, press the
LOCK
button.
To increase the Pulse by 10 ms, press the
START/STOP
To decrease the Pulse by 3 ms, press the
UNLOCK
button.
To decrease the Pulse by 10 ms, press the
TRUNK
button.
6. To save the setting: press
LOCK
and
UNLOCK
. If 3 Honks are heard the new value has been
saved.
For each timing change, the Horn will Honk with the new settings, except under the
following circumstances:
•
When the lower limit of 5 ms is reached, the Horn will sound for 1/4 second.
•
When the upper limit of 200 ms is reached, the Horn will sound for 3/4 second.
A system reset will set the system back to the default: 30 ms
Close the Hood to cancel the changes
Table 4