OPERATION
Operating Instructions:
Control
Notice: Before using the machine, you must be
familiar with the functions and be proficient in
�
ting it.
t'.lNotice:
Before adjWlting or inspecting the tool function,
please be sure to switch off tool power and take out
the battery pack.
Charge
It can be charged normally at ambient
temperature of0-4S"'C.
First insert the battery pack into the charger,
and pl
ug
the charger pl
ug
int.o an appropriate power
socket, by which, the red light on the charger lights
up, indicating that it has entered the normal
charging state. When the red light is off and the
green light is on, check the battery indicator at the
back of the battery pack; if the three lights are all
on, it means the charging has finished. (Note: If the
green light is on, yet not all the three lights of
battery indicator are on, it means the battery pack
or the charger is faulty, please stop using it and
Sllbmit it t.o a professional for maintenance). When
charging is complete, the charger must be
unplugged from the power sowt and the battery
pack must be removed from the charger. After
cooling for a few seconds, the battery pack can be
inserted into the tool for use.
The charger (covered in the scope of supply)
is specially designed for the lithium battery of the
tool. Do not use charger of other brands.
Battery Indicator
In order to let users know the battery status in a
timely manner, the tool is designed with a battery
indicator button and three indicator lights at the tail of
the battery pack. When the battery indicator button is
pressed, if all the three indicator lights are on, it
means the battery is fully clw
ge
d; if only two lights
are on, it me1111S the battery is only about
50%
charged;
if only one light is on, it me1111S the battery is running
out, and needs to be charged as soon as possible.
lnltllllation and Disassembly of Battery Pack
l.Wben the battery pack is insermd in or taken out,
please be sure to switch off1he tool power.
2. When the battery pack is dismantled, press the
button at the end of the battery pack and pull it out
from 1he tool.
3.Wben inserting the battery pack, align the n:ed on
the battery pack with the groove on the holllling and
pll8b the slide in place. Then, be sure to insert it to the
bottom until there is a clicking sound; otherwise, the
battery pack will fall off from the battery pack, which
might cause injuiy to the operator or the others.
4.Do not push too hard when inserting the batch pack.
If the battery pack doesn't slide smoothly, it may be
CBW1ed by improper insertion.
Figure2
Switch variable speed
Control the speed between 0--560RPM, exert
pressure on the switch: the greater the pressure, the
higher the speed.
Floodlight
�otice: do not stare at light or light source!
Pull the trigger to switch on the light When the
trigger is pulled, the light is on; when the tri
gg
er is
released, the light is off. (Fi
gure
3)
Please use clean cloth to wi
pe
the lamp holder in case
of IICl"atching; otherwise it will reduce luminance.
Figure3
Switch forward and revene ronation
This switch can control the steerillg of the fl.enllle
shaft: press the L for forward rotation and press the R
for reverse rotation, when the driving lever is in the
middle and the trigger cannot be pulled
It is required to confirm the rotation direction before
operation.
The forward and reverse rotation pU8h button can be
switched when the tool completely stops rotating.
When tools are not used, please be sure to switch the
forward and reverse rotation pU8h button in the middle
state in case of mis-operation.
6
