20
With the STATUS LED flashing green, press and hold the programming
button until the STATUS LED turns off. The STATUS LED will now slowly
flash green the number of times equal to the current failsafe time (in
seconds). For example, if the failsafe time is set to two, so the LED will flash
two times, indicating a failsafe period of two seconds.
After the flashing stops you have five seconds to change the failsafe time.
To change the failsafe time, press and release the programming button one
time for each additional second you would like the failsafe time to be. For
example, if you wanted the failsafe time to be 1 second, you would press
and release the programming button once. If you wanted the failsafe time
to be 3 seconds, you would press and release the button 3 times.
If you do not press the programming button within 5 seconds, or if the value
you enter exceeds what is allowed, the LED will alternately flash red and
green (error condition occurred) and no change will be made. At this point,
you are back at the programming mode start.
If you do make a change, the LED will blink green/red/orange in rapid
succession to let you know that the change was successful.
FUNCTION 6 – TELEMETRY SETUP
With the STATUS LED flashing orange, press and hold the programming
button until the STATUS LED turns off and then release the button. Press
the button on each telemetry device in the order of importance (satellite
receivers should be first). Telemetry must be enabled using the XDP
software for any sensors that are connected, with the exception of satellite
receivers which do not require the telemetry system to be enabled.
XDP (COMPUTER) INTERFACE
To put the receiver into computer programming mode, press and hold the
programming button and then apply power to the receiver. The STATUS LED
will be solid orange, indicating it is ready for computer programming.