11
SECTION 2 – TRANSMITTER MODULE
After turning on your transmitter, the STATUS LED on the XtremeLink
®
RF
module will light orange briefly followed by either flashing red, if using
Hopping mode 1, or rapidly flashing red if using any of the other hopping
modes. Red indicates there is no connection with an XtremeLink
®
receiver.
When a connection is established, the STATUS LED will light solid green if
using Hopping mode 1, or rapidly flashing green if using any of the other
hopping modes.
Advanced Programming Features
Advanced programming mode allows various features to be changed.
NOTE - Any XtremeLink
®
receiver that has been “bound” to the XtremeLink
®
RF module must be turned off prior to powering on the transmitter.
To enter advanced programming mode, press and hold the PROG button and
then turn on the power to the transmitter. Hold the button until the STATUS
LED changes from off, to green, and then finally to red. This process will
take approximately 7 seconds.
Once you are in programming mode, each time you press and release the
PROG button, the STATUS LED color will change. Below is a table of STATUS
LED colors and their meanings:
STATUS LED
FUNCTION
Solid Red
Set Power Level
Solid Green
Set Hopping Mode
If you press and hold the PROG button while the STATUS LED is any one of
these colors, you will enter the programming for that function.
Additional features will be added in the future.