Xtreme Power Conversion Corporation
XPD0215SL User’s Manual
Page 6
Power Distribution Unit
Back Panel
1:
Power Outlet status LED: Visual indication of user power outlet On/Off status.
2:
System power On/Off status LED: Indication of system power On/Off status.
3:
Ethernet Link status LED: When the LED is illuminated, Ethernet port and a LAN connection are established.
4:
Ethernet speed status LED: Ethernet port have 100M status.
5:
Ethernet Active data status LED: When there is data traffic on the LAN, the LED is illuminated.
6:
Factory Upgrade switch: Allow the user to upgrade the system. The switch is located behind the small front
panel opening.
7:
Factory Default Reset switch: Allow a user to reset the system to factory default settings.
The switch is located behind the small front panel opening.
13:
Local Master Port (DCE, 9 pin DB, female, or RJ-45 socket): This is also a service port for the user to configure
and change the operation setting of system .
14:
USB Port
20:
Power Circuit A - Power Inlet: An NEMA5-15P/IEC320-C14 AC inlet which supplies power (08 Series 1-4 outlets;
16 Series 1-8 outlets).
23:
Power Circuit A - Switched Outlets: AC Outlets that can be switched On, Off or rebooted in response.
Important Safety Precautions for Hardware Installation
Safety Precautions
It is important that you read this section before attempting any of the hardware installation and maintenance
procedures in this guide.
The following instructions are important for your safety and for the function of the unit. Read the instructions
carefully before the installation
WARNING!
To reduce the risk of fire or electrical shock, never remove the cover of the unit. No user serviceable parts inside.
Repair should be done by authorized service personnel only. The unit should be installed in indoors with ambient
temperature and sufficient airflow.
WARNING!
Please ensure the hardware to be disconnected with power supply for installation. It means that the unit’s power
cable and network cables must remain disconnection until you are instructed to make the connections. Follow the
instructions in the procedures carefully. This equipment is requested to be disconnected from the power supply
by removing the power cord(s) from the power outlet. It is therefore important to locate the unit close to a power
outlet that is easily accessible.
