Chapter 5
Settings of
Embroidery Parameters
Owner’s
Manual of BECS- A15 Computerized Control System
39
3.
Press
to finish the setting.
5.2
Instruction on Some Functions within General Parameters
There are brief descriptions of parameters in the appendix 1. Here, we will introduce
some functions mainly used in embroidery.
5.2.1.
Cyclic Embroidery Function
This function is to increase the embroidery productivity.
When the parameter
“To
Do Cyclic
Emb.”
is set as
“Yes”,
the cyclic embroidery
function is activated and the icon
will appear in the main interface. If this
function is
activated, the machine will automatically embroider the patternsated patterns again
without any operation when completing it.
Usually, cyclic embroidery should accompany repetition embroidery and specially
made patterns, and the parameter
“Auto
Origin”
should be also set as
“Yes”.
Thus when
the machine is embroidering the back fabric, the front one can be replaced. After
embroidering the patternsated patterns, the frame will automatically return to the start point
and the machine
will automatically embroider the front fabric again and at this time it’s
possible for user to replace the back one.
5.2.2.
Brake Adjustment (A Must for New Machine)
This function is to adjust the control parameters for braking, so as to fit machines
with different mechanical characters, which is also able to change with the machine
running. Thus this function can help the machinery parts to work better with the computer.
The function depends
on the parameters “Set Brake Para”.
“Set Brake Para” is to adjust the stop position of the main shaft. When the main shaft
often stops at the position below 100 degree, the user can increase the parameter value.
When the main shaft often stops at the position over 100 degree, the user can decrease the
parameter value. Thus the user can adjust the value to let the main shaft stop close to 100
degree. The value can be set between 0 and 30.
After adjusting this parameter, the user can click the task swift key on the panel to
return to the main interface. Click
and
to make the adjustment and check
the
effects of the parameter adjustment. If the user is not satisfied with the effects, he can
press the swift key on the panel to return to the parameter setting interface, where he can
adjust the parameter setting again. Close the parameter setting interface in the end.
