XTM Racing X-Factor2, Operation Manual

Page: 5 / 28

5
RECOMMENDED TOOLS AND SUPPLIES, CONTINUED....
In addition to the items listed on the previous page, the following tools and supplies will also be required to run and maintain your
X-Factor2 RTR Nitro-Powered Monster Truck:
●
Trinity "8 Pack" AA Alkaline batteries - Part # 837801
●
Trinity "4 Pack" AA Alkaline batteries - Part # 837800
●
Trinity "Final Solution" after-run oil - Part # 843744
●
XTM Racing Air Filter Oil - Part # 149571
●
Emerald Nitro Car Cleaner - Part # 340196
●
Small, flat blade screwdriver to make engine adjustments
●
# 2 Phillips head screwdriver and Assorted Metric Hex Wrenches
●
Adjustable Open-End Wrench
●
Assorted weights of silicone shock oil to tune the shocks and differentials (Optional)
Each radio system comes with stickers on the back of the transmitter and on the receiver showing which frequency the radio system
operates on (either in the 27Mhz or 75Mhz band). No two radio systems can operate nearby each other if they are on the same
frequency. You can purchase transmitter and receiver crystals separately and change them if you plan on running your X-Factor2 with
other people. We have provided a list of the frequencies that are available for your radio system.
SECTION 2: BECOMING FAMILIAR WITH YOUR X-FACTOR2
Antenna: Transmits the signal from the transmitter to the receiver. The antenna should be completely extended during use.
Battery Cover: This cover houses the 8 AA Alkaline batteries that power the transmitter.
Crystal: This is the frequency crystal of the transmitter. You can change crystals in both the transmitter and the receiver (in the chassis) so that you
and your friends can drive at the same time. No two radio systems nearby can be operated on the same frequency.
On/Off Switch: Turns the transmitter on and off. Three L.E.D.s show the power status of the batteries.
Servo Reversing Switches: Allow you to quickly and easily change the direction the servos rotate by just flipping the switches on the top of
the transmitter. The switches are located under the removable plastic cover.
Steering Wheel: Controls the X-Factor2's steering. Turn the wheel to the right and the truck turns right. Turn the wheel to the left and the truck turns left.
Steering Dual Rate Control Dial: This dial adjusts the overall travel of the steering servo. Push the dial forward for maximum steering (125%). Pull
the dial back to reduce steering travel (minimum 60%).
Throttle/Brake Trigger: Controls the speed and braking ability of your X-Factor2. Pull the trigger to accelerate, release the trigger to decelerate,
and push the trigger to brake.
Trim Dials: These dials, one for steering and one for throttle/brake control, allow you to fine tune the servo's center by turning the dials on the
transmitter back and forth.
Channel # Frequency Part # (tx/rx)
67427xx/66427xx
01 16.995
02 27.045
03 27.095
04 27.145
05 27.195
06 27.255
61 75.410
90 75.990
Through
67475xx/66475xx
Note that "xx" is the actual channel number
you want to purchase.
27Mhz
75Mhz
Continued On Next Page
☛ ☛
☛ ☛ ☛