XTline XT107050, Manual

Page: 25 / 29

3
Functional Description
The rotary tool is a multi-purpose
tool used to cut, drill, grind,
Sand, engrave, and much more. It
works on a high speed, low
torque principle from 8,000RPM
(rotations per minute) up to
30,000RPM.Set the desired speed
and correct accessory, then
simply hold and guide the tool to
get the job done.
Please see the diagram below to
see the major components of the
tool before use(See figure below).
Prior to use check for damage
that may have occurred during
transportation and read the
manual.
Accessory Installation
WARNING! Always unplug the
tool before changing accessories
making adjustments, or servicing
the too.
To loosen the collet, press down
the shaft lock button and rotate
the shaft until the lock engages.
With the shaft locked, further
rotation is prevented, and the
collet can be loosened and
adjusted accordingly.
WARNING! Do not engage shaft
lock while the rotary tool is
running. Engaging the shaft lock
While the rotary tools are running
can damage the rotary tool and/ or
cause personal injury.
With the shaft lock engaged
loosen the collet nut. Change the
accessory by removing and
inserted a different accessory into
the collet. Push the accessory in
as far as it can go and tighten the
collet nut .Do not over tighten.
Collet size is 1/16"(1.6mm) and
will fit accessories with this shank
size. If you purchase accessories
of a different brand, please make
sure that the collet matches he
shank size of the accessory