XTline XT106061, Handling Instructions Manual, Page: 46 / 47

10
CAUTION:
Although this machine is equipped with a safety clutch, if the drill bit becomes bound in concrete or
other material, the resultant stoppage of the drill bit could cause the machine body to turn in
reaction. Ensure that the main handle and side handle are gripped firmly during operation.
3. When chipping and chiseling at “hammering”:
CAUTION:
○
If the function knob is switched during motor rotation, the tool can start to rotate abruptly, resulting
in unexpected accidents. Make sure to switch the function knob when the motor is at a complete stop.
○
If the tine chisel or flat chisel is used at the position of “rotation hammering”, the tool can start to
rotate, resulting in unexpected accidents. Make sure that they are used at the position of
“hammering”.
(1) Switching to “hammering”
Turn the function knob counterclockwise. Align
▲
of the function knob and of the cover as
illustrated in
Fig. 7.
(2)When fixing working positions of flat chisel such as cold chisel, etc.,
(a) Turn the function knob, Align
▲
of the function knob and of the cover as illustrated in
Fig. 8.
(b) Turn the bit as illustrated in
Fig. 9
and fix the flat chisel to the desired working direction.
(c) Switch the selector lever to “hammering” according to the procedures mentioned in the above item
(1) and secure the position of the tool.
5. Warming up (Fig.10)
The grease lubrication system in this unit may require warming up in cold regions.
Position the end of the bit so makes contact with the concrete, turn on the switch and perform the
warming up operation. Make sure that a hitting sound is produced and then use the unit.
CAUTION:
When the warming up operation is performed, hold the side handle and the main body
securely with both hands to maintain a secure grip and be careful not to twist your body by the
jammed drill bit.
HOW TO REPLACE GREASE
Low viscosity grease is applied to this rotary hammer so that it can be used for a long period without
replacing the grease. Please contact the nearest service center for grease replacement when any grease
is leaking from loosened screw.
Further use of the rotary hammer with lock off grease will cause the machine to seize up reduce the
service life.
CAUTION:
A special grease is used with this machine, therefore, the normal performance of the machine may be
badly affected by use of other grease. Please be sure to let one of our service agents undertake
replacement of the grease.
When you have to replacement the grease by yourself, please following the order:
CAUTION:
Before replenishing the grease, turn the power off and pull out the power plug.
(1) Remove the oil tank cover and wipe off the grease inside.
(2) Supply 30g of XINPU Electric Hammer Grease (Standard accessory, contained in tube) to the
crank case.
(3) After replenishing the grease, install the oil tank cover securely.
NOTE:
The XINPU Electric Hammer Grease is of the low viscosity type. If necessary purchase from an
XINPU Authorized Service Center.