8
APPLICATIONS
○
Drilling holes in concrete
○
Drilling anchor holes
○
Crushing concrete, chipping, digging, and squaring (by applying optional accessories)
PRIOR TO OPERATION
1. Power source check
Ensure that the power source to be utilized conforms to the power requirements specified on the
product nameplate.
2. Switch status check
Ensure that the power switch is in the OFF position. If the plug is connected to a power receptacle
while the power switch is in the ON position, the power tool will start operating immediately, which
could cause a serious accident.
3. Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be kept as short as practicable.
Recommended minimum conductor cross section and max. cable lengths:
Nominal cross section
of conductor
Max. length
1.0mm
2
40m
1.5mm
2
60m
Assembly
1. Install and Removing the SDS-max bit (Fig.1)
CAUTION:
To prevent accidents, make sure to turn the switch off and disconnect to the plug from the power
receptacle.
NOTE
：
When using tools such as Tine chisel, drill bits, etc., make sure to use the genuine parts designated by
our company.
(1) Clean the bit shank and apply grease before inserting the bit.
(2) Insert the bit into the tool. Turn the bit with slight pressure, you can feel a spot where there is a
hitch. At that spot, pull the flex sheath to the direction of an arrow mark and insert the drill bit all
the way until it hits the innermost end.
(3) Pull the bit to make sure it is locked completely.
(4) To remove the bit, fully pull the flex sheath in the direction of the arrow and pull out the tool.
2. Auxiliary handle (Fig.2)
Operate your power tool only with the auxiliary handle
.
The auxiliary handle can be set to any position for a secure and low-fatigue working posture.
Turn the bottom part of the auxiliary handle in counterclockwise direction and swivel the auxiliary
handle to the desired position. Then retighten the bottom part of the auxiliary handle by turning in
clockwise direction.
Pay attention that the band of the auxiliary handle is positioned on the cover as intended for.
Summary of Contents for XT106061
Page 2: ...4 12 11 12 11 10 12 11...
Page 15: ...4 12 11 12 11 10 12 11...
Page 27: ...2 1 2 3 4 5 6 7 8 9 10...
Page 38: ...2 1 2 3 4 5 6 7 8 9 10...
