16
TREADBELT TRACKING ADJUSTMENT
The treadmill is designed so that the tread-belt remains reasonably centered while in use. It is
normal for some belts to drift near one side while in use, depending on a user’s gait and if they
favor one leg. But if during use the belt continues to move toward one side, adjustments are
necessary.
SETTING TREAD-BELT TRACKING
A 6mm Allen wrench is provided for this adjustment. Make tracking adjustments on the left
side bolt. Set belt speed at 3 mph. Be aware that a
small adjustment can make a dramatic difference
which may not be apparent right away. If the belt is
too close to the left side, then turn the bolt only a 1/4
turn to the right (clockwise) and wait a few minutes
for the belt to adjust itself. Continue to make 1/4
turns until the belt
stabilizes in the center of the running deck.
If the belt is too close to the right side, turn the bolt
counter-clockwise. The belt may require periodic
tracking adjustment depending on use and walking/running characteristics. Some users may
affect tracking differently. Expect to make adjustments as required to center the tread-belt.
Adjustments will become less of a maintenance concern as the belt is used. Proper belt
tracking is an owner responsibility common with all treadmills.
ATTENTION
Damage to the running belt resulting from improper tracking / tension adjustments is not
covered under the XTERRA Fitness warranty.
BELT/DECK LUBRICATION PROCEDURE
To ensure the longevity and proper function of your treadmill, proper belt maintenance is
required. You should regularly check between the treadmill belt and the top of the treadmill
base for proper lubrication, and to ensure that no dirt or debris has become trapped. Keeping
the deck clean and lubricated at the recommended intervals ensures the longest life possible
for your treadmill. Should lubrication dry out, or dirt become trapped, the friction between the
belt and deck increases. Increased friction places undue stress on the drive motor, drive belt,
and electronic motor control board which could result in catastrophic failure of these essential,
expensive components.
Failure to clean and lubricate the deck at regular intervals may void the warranty.
As a part of your routine maintenance schedule, belt lubrication and cleaning should be
performed every 80 hours of use, or earlier if you notice that the deck is dry or dirty. Please
also be sure to check belt lubrication before first use. Do not lubricate with anything other
than XTERRA Fitness approved lubricant. Your treadmill comes with one tube of treadmill belt
lubricant. Extra tubes can be ordered directly from: www.xterrafitness.com, or by calling our
customer service department at (870) 336-4286.
Regularly check belt lubrication by completing the following steps:
1. Ensure that your machine is off, and that the power cord is unplugged to minimize risk of
injury.
2. Reach between the running belt and the top of the treadmill base to verify that lubrication is
present.
