SB2.5 Recumbent Bike
7
Seat & Rear Handlebars
3
Hardware Step 3
#55
. M6 x 35mm
Phillips Head Screw
(4 pcs)
#61
. 3/8” x 1-3/4”
Button Head Socket
Bolt (6 pcs)
#62
. 3/8”
Flat Washer (6 pcs)
#63
. 3/8” x 7T
Nyloc Nut (6 pcs)
1. Secure the Seat (
19
) on the sliding seat carriage with four Phillips head
screws (
55
).Tighten with the Combination M5 Allen Wrench & Phillips
Head Screw Driver (
68
). Install Seat Handle Bar (
7
) on the sliding seat
carriage by using M6 L Allen Wrench (
92
) with four Button Head Socket
Bolts (
61
), going through the Seat Handle Bar (
7
), four Flat Washers
(
62
), and four Nyloc Nuts (
63
). Tighten with the 14/15mm Wrench (
69
).
2. Install Seat Back Bracket (
3
) on the Seat Handle Bar (
7
) with by
using M6 L Allen Wrench (
92
) two Button Head Socket Bolts (
61
) going
through the Seat Back Mounting Plate (
54
), then two Flat Washers (
62
),
and two Nyloc Nuts (
63
).Tighten with the 14/15mm Wrench (
69
).
3. Connect the hand pulse connector (
108
and
95
) as shown in the inset
picture below.
