SB2.5 Recumbent Bike
5
1. First, connect Hand pulse Wire (Middle) (
108
) and Hand pulse Wire
(Upper) (
94
). Then join Rear Main Frame (
104
) and Front Main Frame
(
1
) together using the Combination M5 Allen Wrench & Phillips Head
Screw Driver (
68
) to tighten six Button Head Socket Bolts (
32
), six split
washers (
35
) together with six Flat Washers (
33
).
2. Locate the Console Mast (
2
) and slide on the Console Mast Cover (
80
).
Make sure the cover is facing the correct direction, as shown below,
before sliding onto mast. Install the wiring harness into the bottom of the
mast and out the top. Be careful when installing the console mast to the
main frame so as not to pinch or cut the wiring harness, damage to the
console may occur.
3. Install the console mast on the mainframe using the M5 Allen Wrench
(
68
) to tighten five Button Head Socket Bolts (
32
), five Split Washers
(
35
), four Flat Washers (
33
) and one Curved Washer (
34
). Snap the
Console Mast Cover (
80
) down onto the plastic side covers.
4. Connect the cable (
93
) to the Console Assembly (
47
), then install the
console onto the Console Mast (
2
) with four Phillips head screws (
41
).
using the Phillips Head Screw Driver (
68
) to tighten
SB2.5r
Assembly Instructions
Hardware Step 1
Frame, Console Mast & Console
#32
. 5/16” x 3/4”
Button Head Socket
Bolt (11 pcs)
#33
. 5/16” Flat
Washer (10 pcs)
#34
. 5/16” Curved
Washer (1 pc)
#35
. 5/16” Split
Washer (11 pcs)
#41
. M5 x 12mm
Phillips Head Screw
(4 pcs)
1
