CUSTOMER SERVICE 1-888-707-1880
10
Dyaco Canada Inc.©2017
Email: [email protected]
1
Console Mast & Front Stabilizer
1. Slide the Rear Rail into the Main Frame
(1)
. Insert one Button Head Socket Bolt
(80)
through each
side and attach a Flat Washer
(105)
and a Nyloc Nut
(96)
to each joint on the inside.
2.
Attach the Rail Connecting Tube
(4)
to the Rear Rails
(16)
with two Button Head Socket Bolts
(80)
and Curved
Washers
(113)
on each side. Tighten using the L Allen Wrench
(122)
.
3.
Locate the Console Mast
(9)
and Console Mast Cover
(54)
and slide the Cover onto the Mast as far as it will
go. Make sure the Console Mast Cover
(54)
is facing the correct way.
• At the top opening of the Main Frame
(1)
of the elliptical is a Computer Cable
(33)
.
• Unravel and straighten out the Computer Cable
(33)
and feed it into the bottom of the Console Mast tube
(9)
and out of the top opening.
• Install the Console Mast
(9)
into the receiving bracket in the top of the Main Frame and secure with 6 of
Hex Head Bolts
(76)
and 4 of Flat Washers
(103)
, 2 Curved Washers
(112)
. Install, and tighten by using
the Wrench
(118)
.
NOTE:
There is an electrical wire running through the Console Mast Tube
(9)
. Be careful not to damage or
pinch this Computer Cable
(33)
during this procedure.
4. Connect the Front Stabilizer Bar
(2)
with the main frame at front joining plate by using 12/14 mm Wrench
(118)
to tighten 2 of Hex Head Bolt
(78)
, 2 of Split Washers
(114)
and 2 of Curved Washer
(113)
.
5.
Place Console Assembly
(32)
on Console Mast, the Computer Cable
(33)
and Handpulse W/Cable Assembly
(37)
and Handpulse W/Cable Assembly (Red)
plug into the console (the same color to same color), Place
console on the Console Mast and secure with 4 Phillips Head Screw
(83)
by Phillips Head Screwdriver
(120)
(Note: Make sure the wires are inserted into the riser (Do not pinch the wire).
