20
Customer Service 1-888-707-1880 Dyaco Canada Inc. 2018
Email: [email protected]
GENERAL MAINTENANCE
WARNING: Always unplug your treadmill prior to cleaning in order to avoid
electrical hazard or shock.
Belt and Deck
-
Your treadmill uses a very high-efficient low-friction deck. Performance is
maximized when the deck is kept as clean as possible. Use a soft, damp cloth or paper towel to
wipe the edge of the belt and the area between the belt edge and frame. Also, reach as far as
practical directly under the belt edge. This should be done once a month to extend belt and
deck life. Use water only - no cleaners or abrasives. A mild soap and water solution along with
a nylon scrub brush will clean the top of the textured belt.
Allow drying before using.
Belt Dust
-
This occurs during normal break-in or until the belt stabilizes. Wiping excess off
with a damp cloth will minimize buildup.
General Cleaning
-
Dirt, dust, and pet hair can block air inlets and accumulate on the running
belt. On a monthly basis, vacuum underneath your treadmill to prevent buildup.
Once a year, you should remove the black motor hood and vacuum out dirt that may
accumulate
.
UNPLUG POWER
CORD BEFORE THIS TASK.
Cleaning metal surfaces may be accomplished by using a soft cotton or terry cloth rag with a
light application of car wax. Do not use aerosol sprays or pump bottles as they may deposit
wax upon the walking or computer surface. Under no circumstances are you to use ammonia,
oils, silicones, or any other compounds on the rubberized walking surface. The use of such
materials may cause serious injury to the body and/or deteriorate the performance of the
walking surface. Only clean the rubberized walking surface with a damp cloth (water only).
From time to time, the computer surface may collect dust or fingerprints. The use of harsh
chemicals will destroy the protective coating and cause a static buildup that will damage the
components. This surface may be cleaned with specially prepared chemicals found in most
computer supply stores especially made for anti-static surfaces. It is strongly recommended
that you purchase such a cleaning compound.
BELT ADJUSTMENTS:
Tread-belt Tension Adjustment
- Belt tension is not critical for most users. It is very
important for
joggers and runners in order to provide a smooth, steady running surface. The
adjustment must be
made from the right side of the rear roller in order to adjust the tension
with the 6 mm Allen wrench
provided in the parts package. The adjustment bolt
is located at
the end of the right-side rail, as
noted in the diagram below.
Tracking / Tension
Adjustment
Tracking / Tension
Adjustment
Note: Adjustment is through small hole in end