XTA 4 Series, Operator'S Manual, Page: 11 / 58

Operators Manual Page 11
Operating the
4 Series 4 Series 4 Series 4 Series
Note about operation with AudioCore software.
The following operating information covers setup and control of the
4 Series
via the front panel controls only. Please
consult the manual supplied with this software for information regarding full computer control.
Start-up procedure
Switching on the unit will display a brief message detailing the unit type and software version running
== AudioCore DP4XX == == AudioCore DP4XX == == AudioCore DP4XX == == AudioCore DP4XX ==
==Software V 1.00 == ==Software V 1.00 == ==Software V 1.00 == ==Software V 1.00 ==
and all LEDs will briefly illuminate. The unit will then begin its countdown to the wake-up procedure
2
, during which time
the audio will fade up to the level last set. Metering will begin to operate when the fade-up starts.
Preliminary Set-up
The procedure below should be followed when first installing a
4 Series unit 4 Series unit 4 Series unit 4 Series unit
.
Design your crossover! To do this, press
MENU
, and use the
BACK
or
NEXT
key to select ‘
Crossover Crossover Crossover Crossover
sub sub sub sub- - - -menu menu menu menu
’ and then press
ENTER
. Use the
BACK
or
NEXT
key to select ‘
Design a crossover Design a crossover Design a crossover Design a crossover
’
and then press
ENTER
. Finally, use the
BACK
or
NEXT
key to select the desired routing
3
and follow the set-up
wizard to finalise your design.
Note that when in a menu,
ENTER
is always used to confirm selections. The current selection is marked with an
asterisk ‘*’.
Use the
EDIT
keys on each output channel with the
BACK
and
NEXT
keys to select the high pass filters, low
pass filters, parametrics etc. Note that when designing a new crossover, the high and low pass filters will be set
to default values.
Use the
EDIT
keys on each input channel with the
BACK
and
NEXT
keys to select the gain, delay and
parametrics available on each input.
Note that if no action is taken in menu mode, the unit will return to normal ‘default’ mode after about twenty
(20) seconds. Repeat the above directions to return to menu mode.
2
The wake-up time countdown may be adjusted in the SYSTEM menu – see page 23 for details.
3
For details about adjusting the routing if one of the standard configurations does not suit, see page 15.