24
3. Fully immerse the detergent strainer into the detergent solution.
4. Adjust the amount of detergent desired by locating the adjustment
knob at the end of the clear vinyl hose. Turn the knob completely
counterclockwise to set at maximum siphon rate. Be certain the
adjustable grip on the dual lance is turned completely clockwise for
low pressure detergent operation.
5. To apply solution; unlock the trigger gun and squeeze the trigger. In
a few moments a detergent/water mixture will exit the nozzle. Start
spraying the lower portion of the surface being cleaned and move up,
using long overlapping strokes. Applying from the bottom up helps
avoid streaking. Allow to soak briefly. (Avoid working on hot surfaces
or in direct sunlight to minimize the chances of the detergent drying,
which may result in damaging painted surfaces.) Be certain to rinse a
small section at a time.
6. To rinse; lock the trigger gun in the “OFF” position, rotate the
adjustable grip on the dual lance counterclockwise for high pressure.
Unlock the trigger gun and spray. It will take about 30 seconds to
purge all detergent from the line. For best rinsing results, start at the
top and work down.
7. Siphon a gallon of water through the low pressure detergent injection
system after each use. This prevents the possibility of corrosion or
detergent residue causing mechanical problems during the next use.
operation
NOTICE
This injection system is designed to apply detergents under low pres-
sure only. It will not allow detergent solutions to be introduced into the
system unless the dual lance is set in the low pressure mode.
SHUTDOWN
1. Move the Burner Switch to the OFF position.
2. Squeeze the trigger and discharge the water for a period of three
minutes to cool the heat exchanger and high pressure hose.
(Insufficient cool down period of the high pressure hose will cause
excessive wear and eventual rupturing of the hose.)
3. Do not close the choke to stop the engine. Backfire or engine damage
may occur. Turn the engine “OFF” as directed in the engine manual.
4. Move the engine On/Off Switch to the “off” position.
5. Close the engine fuel shut-off valve.
6. Turn off the water supply and trigger the gun momentarily to relieve
trapped pressure.
7. Disconnect and store hoses. Store unit in a non-freezing environment.
