Xstream HW152EMD, Operation Manual

Page: 24 / 66

24
1. Prepare detergent solution according to label directions. Never pump
acids, alkaline, abrasive fluids or solvents through the unit.
2. Adjust the amount of detergent desired by locating the adjustment
knob at the end of the clear vinyl hose. Turn the knob completely
counterclockwise to set at maximum siphon rate.
3. Fully immerse the detergent strainer into the detergent solution.
4. With the trigger gun locked in the “OFF” position, securely quick-
connect the detergent spray nozzle (#65 40° BLACK) into the end of
the wand.
5. To apply solution; unlock the trigger gun and squeeze the trigger. In
a few moments a detergent/water mixture will exit the nozzle. Start
spraying the lower portion of the surface being cleaned and move up,
using long overlapping strokes. Applying from the bottom up helps
avoid streaking. Allow to soak briefly. (Avoid working on hot surfaces
or in direct sunlight to minimize the chances of the detergent drying,
which may result in damaging painted surfaces.) Be certain to rinse a
small section at a time.
6. To rinse; lock the trigger gun in the “OFF” position, securely quick-
connect the desired high pressure nozzle into the end of the wand.
Unlock the trigger gun and spray. It will take about 30 seconds to
purge all detergent from the line. For best rinsing results, start at the
top and work down.
7. Siphon a gallon of water through the low pressure detergent injection
system after each use. This prevents the possibility of corrosion or
detergent residue causing mechanical problems during the next use.
CLEANING WITH DETERGENTS UNDER LOW PRESSURE
NOTICE
The burner will shut down if the switch is moved to “Steam” without
first setting the unloader to minimum or operating in the high pressure
mode.)
NOTICE
This feature is designed for use with mild detergents only. Since the
cleaning solution travels through the heat exchanger coil, DO NOT
use corrosives as they will cause extensive damage as well as pose a
considerable safety hazard.
NOTICE
This injection system is designed to apply detergents under low pres-
sure only. It will not allow detergent solutions to be introduced into the
system unless the adjustable nozzle is set in the low pressure mode.
operation