Xstrahl RADiant, Operator'S Manual

Page: 31 / 46

RADiant Operator Manual
PHET_OP_GB Version 7 ©2017 Xstrahl Ltd. All rights reserved 12/02/18 | 3-1
Section 3:
Xstrahl RADiant Operation
_________________ In this section ___________________
1.1 ........... Ionising Radiation ........................................... 1-1
1.2 ........... Maintenance of Equipment ............................. 1-1
1.3 ........... Portable Personal Electronic Devices .............. 1-2
______________________________________________________
3 Xstrahl RADiant Therapy System Operation
Note:
Operating environment limits for Xstrahl equipment is 10 to 35ºC, with 20
to 80% ambient relative humidity (non-condensing).
3.1
Power On
If the Xstrahl System has been installed with a connection to a mains
isolator, the isolator needs to be placed in the
On position. The location of
the mains isolator will vary between sites and is customer dependent
(established during installation process). If th Xstrahl System has been
connected to a mains socket, insert plug into socket. If socket is switch,
place in the
On
position.
To power on your Xstrahl System:
1. Turn On the mains power isolator switch or plug the mains cable into
the socket.
This applies mains power to the following system components:
•
Generator
•
Cooling system
•
Tube stand
•
Safety interlocks
2. Turn the key switch on the operator control pod to Standby (position 2)
to initiate power. The Power On indicator will illuminate to indicate
the power on status.
Note:
Power will also be applied to the controlled area warning lights to indicate
the area is classified as a controlled area in respect to the ionising radiation
regulations.
3. Power on the Xstrahl PC and monitor screen located in the control
area.
4. Select either Fisica or Concerto.
5. Using the mouse, double click the icon.