Rev.: 20100413
© 2010 Directed Electronics. All rights reserved.
FORD TAURUS 2010
Push-to-start
CANMAX400DEI-LINCOLN1
First, you have to dock the
CANMAX400DEI into the
module. Connect USB cable to
the XKLoader2 and plug USB to
any available USB port on your
PC. Then connect the XKD2D65
wire into the module in which you
docked the CANMAX400DEI,
and connect the XKD2D65 to
XKLoader2.
XKLOADER2
USB
Connector
4 PIN D2D
4 PIN D2D
Option A: XKLOADER2
USB Port
Rev
8C
and
above
PART#
XKD2D65
XKLINT
Red
12v
Black
Ground
XKLoader2
USB
Connector
XKLINT
4 PIN D2D
Connect the 7 pin from the harness into
connector of the CANMAX400DEI.
Connection to XKLoader2
Connect USB cable to the XKLoader2 and plug USB to any available USB port on
your PC. Next connect the wire adaptor cable into the XKLoader2, connect the 7 pin
connector under the CANMAX400DEI and finally connect Red wire to a 12v power
source and Black wire to a ground source.
1
Option B: XKLINT
2
XKLINT
USB Port
CANMAX400DEI
CANMAX400DEI
1
Remove cover from the
module and cut the lip to
allow docking of the
CANMAX400DEI.
Cut the lip
Jumper
position
2
3
Before powering the system,
make sure a jumper is placed on
the two
pins and no jumper
is placed on the upper pins of the
module.
lower
Jumper
If using a Remote/Alarm system with Rev 8B and below, please go to Option B.
Bootloading
Default jumper setting on module and
operating mode for CANMAX400DEI.
Setting for flashing the
CANMAX400DEI when docked into
the module.
Jumpers settings
Operating
Position
Flashing
Position
2
Caution!
The 20 pin connector can be easily plugged in backwards.
Connect the 20 pin harness to the CANMAX400DEI.
Connect 20 pin to module
Remove cover from the module and cut the lip to allow docking
of the CANMAX400DEI.
Cut the lip
Dock the CANMAX400DEI into the module.
Dock it
Make all connections as per wiring schematics.
Wiring
Please Note:
Failure to proceed in the following order could result in possible vehicle damage.
1
4
3
Make the necessary connections in the vehicle, as
instructed in the module guide.
Connect the remote
starter to the vehicle
If your module has D2D Jumpers, make sure both Jumpers are in the
position.
horizontal
Installation Procedure Overview
5
6
Module programming
See details on page 5.
